Operation Manual

English
23
Caution:
• The projector enters wired control mode automatically and cannot be controlled by a remote controller’s IR signal
once the terminal of a remote controller is inserted in the projector’s wire port. To control your projector with
the IR signal of a remote controller again, remove the wire control terminal from the projector.
• Make sure the port is valid before inserting a wired remote controller. The remote controller may be damaged if a
port is invalid, e.g. a wired remote controller is connected to trigger output.
Connect to screen trigger
You may connect a projector screen or other 12V trigger device to the projector and turn on
trigger output in OSD Control->Trigger. The trigger port supplys the 12 V signal after the projector
is powered on. After the projector is powered on it outputs 12V signal be adhere to current aspect
ratio and screen control settings for projector screen control.
Screen