User Guide
Table Of Contents
- Table of contents
- Important safety instructions
- Introduction
- Positioning your projector
- Connection
- Operation
- Starting up the projector
- Adjusting the projected image
- Using the menus
- Securing the projector
- Switching input signal
- Magnifying and searching for details
- Selecting the aspect ratio
- Optimizing the image
- Setting the presentation timer
- Remote paging operations
- Freezing the image
- Hiding the image
- Locking control keys
- Operating in a high altitude environment
- Adjusting the sound
- Using the test pattern
- Using the teaching templates
- Presenting from a USB Reader
- Shutting down the projector
- Direct power off
- Menu operation
- Maintenance
- Troubleshooting
- Specifications
- Warranty and Copyright information
Operation 39
Note that the menu items are available when the projector detects at least one valid signal.
If there is no equipment connected to the projector or no signal detected, limited menu
items are accessible.
Main menu Sub-menu Options
5.
SYSTEM
SETUP:
Advanced
High Altitude Mode On/Off
Audio Settings
Mute On/Off
Volume
Power On/Off
Ring Tone
On/Off
Lamp Settings
Lamp Mode Normal/Economic/SmartEco
Reset Lamp Timer
Equivalent Lamp
Security
Settings
Change Password
Change Security
Settings
Power On Lock
Web Control Lock
Baud Rate
2400/4800/9600/14400/19200/
38400/57600/115200
Test Pattern On/Off
Closed Caption
Closed Caption
Enable
On/Off
Caption Version CC1/CC2/CC3/CC4
Standby
Settings
Network On/Off
Monitor Out On/Off
Audio Pass
Through
Off/Computer 1/Computer 2/
Video,S-Video/HDMI
Network
Settings
Wireless LAN
Status
SSID
SSID Display
IP Address
Connection Mode
Apply
Projection Log In
Code
On/Off
Reset All Settings
6.
INFORMA
TION
Current System Status
• Source
• Picture Mode
• Resolution
• Lamp Mode
• 3D Format
• Color System
• Equivalent Lamp
• Firmware Version