Service manual

83
2.
2. 2.
2. Assembly FM:
Assembly FM:Assembly FM:
Assembly FM:
2.1 Place FM on “HSG DMD” surface(Fig. 2-1) and use “Clip FM” to fix FM(Fig. 2-2).
Fig. 2-1 Fig. 2-2
3
33
3.
..
. Assembly HSG ILL Module:
Assembly HSG ILL Module:Assembly HSG ILL Module:
Assembly HSG ILL Module:
3.1 CM Assembly
i. Insert “Clip CM Side” first, and then place “Clip Front CM” to fixed-shaft of ILL SUB before
locking screw (Fig. 3-1, Fig. 3-2).
ii. Assemble Mylar SUB HSG to HSG ILL well (Fig. 3-3).
iii. Assemble CM to HSG ILL and to make CM contact three datum on the HSG ILL well (Fig.
3-3).
iv. Assemble” MYLAR CM ” to the CMD firstly, “CLIP TOP CM”(with forceps) to the “HSG ILL”
(Fig. 3-4,).
v. To check and make sure “CLIP of CM” hooks the HSG ILL very Well (Fig. 3-5).
Fig. 3-1 Fig. 3-2
Touch the side
surface
Push Clip FM
to HSG
M2*3.5L Screw
Clip CM Side
Fixed shafts of
ILL SUB