Service manual

39
A minor defect is a defect that is not likely to reduce materially the usability of its
intended purpose, or is a departure from established standards having little
bearing on the effective use of operation of the product.
Note: If BenQ defect undefined failure, and it judged that is reduce the merchandisebility, BenQ
CM Inform this defect. After that parties make communication and decide how to solve.
6.0
6.06.0
6.0 EXPRESSION OF DEFECTIVES
EXPRESSION OF DEFECTIVESEXPRESSION OF DEFECTIVES
EXPRESSION OF DEFECTIVES
Number of defects
Percent of defects = ------------------------------------------ X 100%
Number of products inspected
7.0 INSPECTION STANDARD
7.0 INSPECTION STANDARD7.0 INSPECTION STANDARD
7.0 INSPECTION STANDARD
Unless otherwise specified, the inspection standard will be defined by MIL-STD-105E,
NORMAL INSPECTION LEVEL , SINGLE SAMPLING PLAN.
7.1 Acceptance Quality Level
7.1.1 C
7.1.1 C7.1.1 C
7.1.1 Critical Defect:
ritical Defect:ritical Defect:
ritical Defect:
When a critical defect is found, this must be reported immediately upon
detection, the lot or batch shall be rejected and further shipments shall be
held up pending instructions from the responsible person in relevant
department.
7.1.2 und
7.1.2 und7.1.2 und
7.1.2 under normal sampling
er normal samplinger normal sampling
er normal sampling
Critical
Defective : 0% AQL
Major
Defective : 0.65% AQL
Minor Defective : 2.5% AQL
8.0 GENERAL RULES
8.0 GENERAL RULES8.0 GENERAL RULES
8.0 GENERAL RULES
8.1 The inspection must be carried out by trained inspectors who have good knowledge about
the product.
8.2 The inspection must be based upon the documents concerning the completely assembled
and packed product.