Operation Manual

Operation 51
Function Description
Baud Rate
Selects a baud rate that is identical with your computer’s so that you
can connect the projector using a suitable RS-232 cable and update or
download the projector’s firmware. This function is intended for
qualified service personnel.
Test Pattern
See "Using the test pattern" on page 38 for details.
Closed
Caption
Closed Caption Enable
Activates the function by selecting On when the selected input signal
carries closed captions.
• Captions: An on-screen display of the dialogue, narration, and
sound effects of TV programs and videos that are closed captioned
(usually marked as "CC" in TV listings).
Caption Version
Selects a preferred closed captioning mode. To view captions, select
CC1, CC2, CC3, or CC4 (CC1 displays captions in the primary
language in your area).
Standby
Settings
Network
• Enable Network Standby Mode
Selecting On enables the function. The projector is able to provide
the network function in standby mode. Selecting Off disables the
function. The projector does not provide the network function in
standby mode.
• Auto Disable Network Standby Mode
Allows the projector to disable the network function after a set
period of time after it enters standby mode. For instance, if 20 min
is selected, the projector is able to provide the network function
for 20 minutes after it enters standby mode. When 20 minutes is
up, the projector enters normal standby mode.
This function is only available when Enable Network Standby Mode is
On.
MHL Charging
Selecting On enables the function. The projector will automatically
charge the connected MHL compatible smart device as long as the
power is fed to the projector.
Monitor Out
Selecting On enables the function. The projector can output a VGA
signal when it is in standby mode and the COMPUTER 1 jack is
correctly connected to devices. See "Connection" on page 18 for how
to make the connection.
Audio Pass Through
The projector can play sound when it is in standby mode and the
corresponding jacks are correctly connected to devices. Press / to
choose the source that you wish to use. See "Connection" on page 18
for how to make the connection.
Enabling this function slightly increases the standby power consumption.
5. SYSTEM SETUP: Advanced menu