User Guide
Table Of Contents
- Table of contents
- Important safety instructions
- Introduction
- Positioning your projector
- Connection
- Operation
- Starting up the projector
- Adjusting the projected image
- Using the menus
- Securing the projector
- Switching input signal
- Magnifying and searching for details
- Selecting the aspect ratio
- Optimizing the image
- Setting the presentation timer
- Remote paging operations
- Hiding the image
- Freezing the image
- Operating in a high altitude environment
- Adjusting the sound
- Personalizing the projector menu display
- Select the lamp saver mode
- Shutting down the projector
- Menu operation
- Maintenance
- Troubleshooting
- Specifications
- Warranty and Copyright information
Operation 51
FUNCTION DESCRIPTION
Picture Mode
Pre-defined picture modes are provided so you can optimize your
projector image set-up to suit your program type. See "Selecting
a picture mode" on page 36 for details.
Reference
Mode
Selects a picture mode that best suits your need for the image
quality and further fine-tune the image based on the selections
listed on the same page below. See "Setting the User 1/User 2
mode" on page 36 for details.
Brightness
Adjusts the brightness of the image. See "Adjusting Brightness"
on page 37 for details.
Contrast
Adjusts the degree of difference between dark and light in the
image. See"Adjusting Contrast" on page 37 for details.
Color
Adjusts the color saturation level -- the amount of each color in a
video image. See "Adjusting Color" on page 37 for details.
Tint
Adjusts the red and green color tones of the image. See
"Adjusting Tint" on page 37 for details.
Sharpness
Adjusts the image to make it look sharper or softer. See
"Adjusting Sharpness" on page 37 for details.
2. PICTURE menu