User Guide
Table Of Contents
- Table of contents
- Important safety instructions
- Introduction
- Positioning your projector
- Connection
- Operation
- Starting up the projector
- Adjusting the projected image
- Using the menus
- Securing the projector
- Switching input signal
- Magnifying and searching for details
- Selecting the aspect ratio
- Optimizing the image
- Setting the presentation timer
- Remote paging operations
- Hiding the image
- Freezing the image
- Operating in a high altitude environment
- Adjusting the sound
- Personalizing the projector menu display
- Select the lamp saver mode
- Shutting down the projector
- Menu operation
- Maintenance
- Troubleshooting
- Specifications
- Warranty and Copyright information
Operation
48
Note that the menu items are available when the projector detects at least one valid
signal. If there is no equipment connected to the projector or no signal detected,
limited menu items are accessible.
5.
SYSTEM
SETUP:
Advanced
High Altitude
Mode
On/Off Yes/No
Fan Speed
Mode
High/Normal
Yes/No
Audio Settings
Mute On/Off
Volume 0~10
Power On/Off Ring
Tone
On/Off
Lamp Settings
Lamp Mode Normal/Economic/SmartEco
Reset Lamp Timer
Reset/Cancel
Equivalent Lamp Hour
Security
Settings
Change Password
Change Security Power on lock
Baud Rate
2400/4800/9600/14400/19200/
38400/57600/115200
Test Pattern On/Off
Closed
Caption
Closed Caption Enable On/Off
Caption Version CC1/CC2/CC3/CC4
Standby
Settings
Monitor Out On/Off
Audio Pass Through Off/Audio In/HDMI-1/HDMI-2
Reset All
Settings
Reset/Cancel
6.
INFORMA
TION
Native Resolution
Current System Status
Source
Picture Mode
Resolution
Lamp Mode
3D Format
Color System
Equivalent Lamp Hour
Firmware Version