User Guide
Table Of Contents
- Table of contents
- Important safety instructions
- Introduction
- Positioning your projector
- Connection
- Operation
- Starting up the projector
- Adjusting the projected image
- Using the menus
- Securing the projector
- Switching input signal
- Magnifying and searching for details
- Selecting the aspect ratio
- Optimizing the image
- Setting the presentation timer
- Remote paging operations
- Hiding the image
- Freezing the image
- Operating in a high altitude environment
- Adjusting the sound
- Personalizing the projector menu display
- Select the lamp saver mode
- Shutting down the projector
- Menu operation
- Maintenance
- Troubleshooting
- Specifications
- Warranty and Copyright information
Operation
30
Using the menus
The projector is equipped with On-Screen Display (OSD) menus for making various
adjustments and settings.
Below is the overview of the OSD menu.
The following example describes how to set the OSD language.
1. Press MENU on the projector or
remote control to turn the OSD
menu on.
3. Press to highlight
Language and press OK.
2. Use / to highlight the
SYSTEM SETUP: Basic menu.
4. Press / / / to select a
preferred language and press
OK to leave and save the
settings.
* Press MENU to open and
close the OSD menu.
* Press BACK to
go back to
previous OSD menu or exits
and saves menu settings when
it is on top level of OSD
menu.
Current input
Main menu icon
Main menu
Sub-menu
Highlight
Press
MENU to
the
previous
page or to
exit.
Status