User Guide
Table Of Contents
- Table of contents
- Important safety instructions
- Introduction
- Positioning your projector
- Connection
- Operation
- Starting up the projector
- Adjusting the projected image
- Using the menus
- Securing the projector
- Switching input signal
- Magnifying and searching for details
- Selecting the aspect ratio
- Optimizing the image
- Setting the presentation timer
- Remote paging operations
- Hiding the image
- Freezing the image
- Operating in a high altitude environment
- Adjusting the sound
- Personalizing the projector menu display
- Select the lamp saver mode
- Shutting down the projector
- Menu operation
- Maintenance
- Troubleshooting
- Specifications
- Warranty and Copyright information
Operation
28
Auto-adjusting the image
In some cases, you may need to optimize the
picture quality. To do this, press AUTO on
the projector or remote control. Within 3
seconds, the built-in Intelligent Auto
Adjustment function will re-adjust the values
of Frequency and Clock to provide the best
picture quality.
• This function is only available when
PC signal (analog RGB) is selected.
Use build-in test pattern
You can adjust the image shape and focus status by observing the input signal content,
or using the test pattern build-in OSD manual from OSD or remote control for
better observe the shape changed.
• Using the remote control
Press the Quick Install to display Quick
Install menu, and go to the Test Pattern
> On. The Test Pattern displays.
•Using the OSD menu
Open the OSD menu and go to the
SYSTEM SETUP: Advanced > Test
Pattern > On. The Test Pattern displays.