User Guide
Table Of Contents
- Table of contents
- Important safety instructions
- Introduction
- Positioning your projector
- Connection
- Operation
- Starting up the projector
- Adjusting the projected image
- Using the menus
- Securing the projector
- Switching input signal
- Magnifying and searching for details
- Selecting the aspect ratio
- Optimizing the image
- Setting the presentation timer
- Remote paging operations
- Hiding the image
- Freezing the image
- Operating in a high altitude environment
- Adjusting the sound
- Personalizing the projector menu display
- Select the lamp saver mode
- Shutting down the projector
- Menu operation
- Maintenance
- Troubleshooting
- Specifications
- Warranty and Copyright information
Introduction14
Infra-Red (IR) remote control sensor is located on the front of the projector. The
remote control must be held at an angle within 30 degrees perpendicular to the
projector's IR remote control sensor to function correctly. The distance between the
remote control and the sensor should not exceed 8 meters (~ 26 feet).
Make sure that there are no obstacles between the remote control and the IR sensor
on the projector that might obstruct the infra-red beam.
15. AUTO
Automatically determines the best
picture timings for the displayed
image. See "Auto-adjusting the image"
on page 28 for details.
16. Mute
Toggles projector audio between on
and off.
17. Digital Zoom keys (ZOOM +/-)
Magnifies or reduces the projected
picture size. See "Magnifying and
searching for details" on page 34 for
details.
18. Volume keys (VOL / )
Adjusts the sound level.
19. SMART ECO
Displays the lamp mode selection bar
(Normal/Economic/SmartEco).
20. INFO
Displays the status information of the
projector.
21. QUICK INSTALL
Displays the QUICK INSTALL menu
including Projector Installation, Test
Pattern, and Keystone.
22. ASPECT
Selects the display aspect ratio. See
"About the aspect ratio" on page 35 for
details.
• Operating the projector from
the front
A
p
pr
o
x
.
3
0°