User manual
Table Of Contents
- Table of contents
- Important safety instructions
- Introduction
- Positioning your projector
- Connection
- Operation
- Starting up the projector
- Adjusting the projected image
- Using the menus
- Securing the projector
- Switching input signal
- Magnifying and searching for details
- Selecting the aspect ratio
- Optimizing the image
- Setting the presentation timer
- Remote paging operations
- Hiding the image
- Freezing the image
- Operating in a high altitude environment
- Adjusting the sound
- Use Teaching Template
- Personalizing the projector menu display
- Select the lamp saver mode
- Shutting down the projector
- Menu operation
- Maintenance
- Troubleshooting
- Specifications
- Warranty and Copyright information
Operation
48
Note that the menu items are available when the projector detects at least one valid signal.
If there is no equipment connected to the projector or no signal detected, limited menu
items are accessible.
5.
SYSTEM
SETUP:
Advanced
High Altitude
Mode
On/Off Yes/No
Audio Settings
Mute On/Off
Volume 0~10
Lamp Settings
Lamp Mode Normal/Economic/SmartEco
Reset Lamp Timer Reset/Cancel
Equivalent Lamp
Security Settings
Change Password
Change Security Power on lock
Baud Rate
2400/4800/9600/14400/19200/
38400/57600/115200
Test Pattern On/Off
Closed Caption
Closed Caption Enable On/Off
Caption Version CC1/CC2/CC3/CC4
Standby Settings
Monitor Out On/Off
Audio Pass Through
Off/Computer 1/Computer 2/
Video, Svideo/HDMI
Reset All Settings Reset/Cancel
6.
INFORMA
TION
Current System Status
•Source
•Picture Mode
•Resolution
•Lamp Mode
•3D Format
•Color System
• Equivalent Lamp
•Firmware Version