Operation Manual

English
80
Troubleshooting
Indicator messages
Several indicator messages are used by the projector to alert users about problems with setup or
system error. The LEDs on top cover of the projector illustrated below.
TEMP LED
LED display Projector status Operation tips
Off Normal status
Flashing Red Over temperature error
Contact with your nearest authorized dealer or service
center.
LIGHT SOURCE LED
LED display Projector status Operation tips
Off Light source is off
Flashing
Green Projector is turning on
Red (Cycles of 6) Light source is end-of-life Please call the local service center.
On
Red Light source problem Please call the local service center.
Green Light source is on
STATUS LED indicator
LED display Projector status Operation tips
Close Normal
Flashing
Red (once) Safety switch error
Please check whether the top cover is well assembled
or lens is well installed or not. If the problem persists,
call the local service center.
Red
(quadruple)
Fan error Call the local service center.
Lights up Red System error Call the local service center.
POWER LED indicator
LED display Projector status Operation tips
Close AC power turned off Check AC power source and power on the projector.
Flashing
Green
Ready to power on the
projector
Wait until the projector starts projecting.
Orange
The projector is cooling
down
Lights up
Red Standby mode
To power on the projector, press the ON key on the
remote controller or the Power key on the control
panel.
Green Projector powered on