Operation Manual

English
55
OSD menu - System
Standby Mode Eco
Off
Off
Off
Off
On
Logo
Auto Power Off
Direct Power On
Network
Background
Startup Logo
Trigger
Dynamic Black
Reset System
No Signal MENU Exit
Picture
System
Display Setup Advanced System Information
• Standby Mode
Press
◄►
arrow key to toggle switch between Network and Eco mode.
Network: The projector maintains in the standby status at the power consumption under 6W,
the projector can be turned on using the power button or network control only, RS-232 control
command and wired remote control signal via external transmitter through RJ45 cable are not
available.
Eco: The projector maintains in the standby status at the lowest power (<0.5W). In this mode,
the projector can be turned on only using the power button on the remote controller or
projector.
Note:
Some of communication ports are turned off if it is set to Eco or Network mode. Please make sure that the standby
mode is set to proper setting.
• Auto Power off
The default setting is Off. The projector powers off automatically after 20 minutes without input
signal when set to On.
• Direct Power on
The default setting is Off. The projector powers on automatically once it is connected to any
AC power supply if set to On.
• Network
You can use the network function to congure a network for projector control.