Operation Manual

English
50
OSD menu - Setup
Language
Projector Installation
Auto Source Search
Lens Control
Lens Memory
Center Lens
Digital Zoom
Light Settings
Test Pattern
Reset Setup
Front Table
Off
No Signal
MENU Exit
Picture
Setup
Display Setup Advanced System Information
• Language
Select desired language displayed in your OSD menu: English, Français, Español, Deutsch,
Português,
簡体中文
,
繁體中文
,
日本語
,
한국어
, Svenska,
Русский
, Italiano.
• Projector Installation
Press
◄►
arrow key to select Projector Installation : Front Table, Rear Table, front Ceiling, rear
Ceiling.
Caution:
The cooling fan speed varies with projection mode to ensure the projector to properly
discharge heat. Be careful to choose the correct projection mode when installing your projector.
• Auto Source Search
Press
◄►
arrow key to enable/disable the Auto Source Search.
• Lens Control
Select this function or press the LENS Shift button on the remote controller to open the lens
control menu to zoom, focus or shift the lens. Press Enter key to switch zoom/focus or lens shift
menu, press
◄►
arrow key focus the projected image or shift the lens in horizontal direction,
and
◄►
to zoom the projection size or shift the lens in vertical direction.
Lens Control
[Enter] Shift Adjustment
Zoom
Focus
Lens Control
[Enter] Zoom/Focus Adjustment
Shift
• Lens Memory
The projector can memorize up to 10 sets of zoom, focus, and lens shift. You can give each
group of settings a unique name with the virtual keyboard. You can save current lens position
(horizontal and vertical), zoom and focus settings as well as retrieve and load saved lens memory
for the projector to apply the newly loaded lens shift, zoom, and focus settings.
Load Memory: To recall saved lens settings: press Enter key to display lens memory list, press