Operation Manual

English

Making connections

Preparations

When connecting a signal source to the projector, be sure to:

1. Turn off all equipment before making any connections.

2. Only use the correct type cables for each source with proper type plugs.

3. Ensure that all cable plugs are rmly tted to the equipment jacks.

Note that all cables shown in the following connection diagrams may not be supplied with the projector (See "Shipping

contents" on page 13 ). Most cables are commercially available from electronics stores.

Connect to PC

You may connect a PC to your projector with a DVI-D, HDMI, RGB or RGBHV (BNC) cable for

projection, and connect an external display to your projector for concurrent viewing if the input is

RGB signal.