User manual

Using BIOS setup44
• Password on boot: When you select Enabled, the
Supervisor Password is required whenever starting up your
Joybook. Select
Disabled if you do not want to use the
Supervisor Password.
Boot menu
The Boot menu contains the boot configuration settings of the
system and sets the sequence of boot devices. The system will try
to boot from the first device. If it is not available, the system will
try the next boot device.
a. Use <K> or <L> to select a device.
b. Press <F5> or <F6> to move the selected device up or
down in the booting sequence.
Exit menu
The Exit menu displays ways of exiting BIOS setup. After
finished with your settings, you must save and exit so that the
new settings can take effect.
•
Exit Saving Changes: saves the changes you have made and
exits BIOS setup. After finishing with your settings, you must
save and exit so that the new settings can take effect.
•
Exit Discarding Changes: exits BIOS setup without saving
the changes you have made.
•
Load Setup Defaults: loads the default values for all the
items in the BIOS setup utility.
•
Discard Changes: cancels all changes you have made.
•
Save Changes: saves the changes you have made.
It is recommended that you go into BIOS to load manufacture
defaults, whenever you have installed new hardware
components.
JB_R48_UM EN.book Page 44 Tuesday, April 13, 2010 5:47 PM
Downloaded from LpManual.com Manuals