Operation Manual
Table Of Contents
- Table of contents
- Important safety instructions
- Introduction
- Positioning your projector
- Connection
- Connecting the power
- Connecting a computer
- Connecting Video source devices
- Connecting an HDMI source device
- Connecting a Component Video source device
- Connecting a Composite Video source device
- Connecting an iPhone/iPod device
- Connecting an external speaker
- Connecting a wireless dongle
- Connecting to an external memory device
- Playing sound through the projector
- Operation
- Starting up the projector
- Switching input signal
- Adjusting the projected image
- Hiding the image
- Securing the projector
- Selecting the aspect ratio
- Optimizing the image
- Operating in a high altitude environment
- Adjusting the sound
- Firmware upgrade
- Personalizing the projector menu display
- Playing files with iPhone/iPod
- Using iPhone/iPod pop-up menus
- Displaying images with PC and Video source devices
- Using PC/ Video pop-up menus
- Displaying files with internal memory, USB Drive and SD card
- Using USB Streaming
- Using Wireless Streaming
- Settings menu
- Shutting down the projector
- Maintenance
- Troubleshooting
- Specifications
- Warranty and Copyright information
Operation
45
Adjusting the sound level
To adjust the sound level, press +/- on the projector or /
on the remote control,
Setting the keypad tone
To set the keypad tone:
1. Repeat steps 1-2 in Muting the sound
section.
2. Highlight Keypad tone and press OK to
open the pop-up menu.
3. Highlight On and press OK to confirm.
4. To leave the OSD, follow step 5 in Muting the
sound section.
Setting the audio in standby mode
To set the audio in standby mode:
1. Repeat steps 1-2 on muting the sound
section.
2. Highlight Audio in Standby Mode and
press OK to open the pop-up menu.
3. Highlight iPhone& iPod and press OK to
confirm. After set on the Audio in Standby
Mode, the projector can act as a docking
speaker when music playback is in standby
mode.
4. To leave the OSD, follow step 5 in Muting the sound section.
If Settings > Advanced > Audio Settings > Audio in Standby Mode is set to iPhone/iPod, the
projector can act as a docking speaker when music playback is in standby mode.
Tu r n i n g o n / o f f S R S H D
To turn on/off SRS HD surround sound effects:
1. Repeat steps 1-2 on muting the sound
section.
2. Highlight SRS HD and press OK to open
the pop-up menu.
3. Highlight On/Off and press OK to confirm.
4. To leave the OSD, follow step 5 in Muting the
sound section.