User Manual

15 How to change cable connection after initial installation
How to change cable connection after initial installation
To protect the curved screen, do not lay the screen face down on the desk without the
protection of the supplied cushion. If you prefer to change the cable connection after the initial
installation has been completed in How to assemble your monitor hardware on page 10, follow
the procedures below.
1. Turn off the monitor.
Turn off the monitor and the power before unplugging
the power cable. Turn off the computer before
unplugging the monitor signal cable.
2. Tilt the monitor to its extended position.
Gently tilt the monitor to the maximum extended
position. To properly tilt the monitor, see Tilt the
monitor. on page 13.
3. Remove the back cover.
Remove the back cover from its bottom as illustrated.
Follow the instructions in Establish a video cable
connection. on page 11 and change connected cables.
Re-install the back cover as instructed in Install the back
cover. on page 12.