Owners manual

9 How to assemble your monitor hardware

How to assemble your monitor hardware

• If the computer is turned on, you must turn it off before continuing.

Do not plug-in or turn-on the power to the monitor until instructed to do so.

• The following illustrations are for your reference only. The location and available input and output jacks may

vary depending on the purchased model.

• The supported timing may vary by input signal. Refer to the "Preset display modes" section on the link

"Adjusting the Screen Resolution" on the CD for more information.

1. Attach the monitor base.

Your monitor comes with a curved screen and the screen surface should never be placed on the desk without a

cushion underneath.

Please be careful to prevent damage to the monitor. Placing the screen surface on an object like a stapler or a

mouse will crack the glass or damage the LCD substrate voiding your warranty. Sliding or scraping the monitor

around on your desk will scratch or damage the monitor surround and controls.

Orient and align the stand base socket with the end of

the stand arm. Tighten the thumbscrew on the bottom

of the monitor base as illustrated.

Be careful when handling the sharp monitor base and

protect yourself from any physical harm.

While the monitor is still inside the box, remove the

cushion that protects the back of the monitor.