T2210HD/T2210HDA 21.
Table of Contents Package contents ..................................................................................................................3 Installation .............................................................................................................................4 To connect the monitor to your PC .......................................................................... 4 Adjusting your monitor .......................................................................................
1. Package contents 1. LCD Monitor 2. Monitor Base (the shape of base may vary according to the monitor model) 3. Power Cord (plug may vary according to the electrical standards for your area) 4. Analog Signal Cable 5. Digital Signal Cable (optional) 6. Audio Cable 7. Quick Installation Guide 8. CD-ROM (contains user manual) Please install monitor drivers from the CD-ROM. The T2210HD driver is named "BENQT2200HD.inf", and the T2210HDA driver is named "BENQT2200HDA.inf".
2. Installation To connect the monitor to your PC Make sure that the PC and monitor are unplugged. 1. Connect the signal cable (VGA or DVI) to the monitor and the PC. 2. Connect the audio cable to the monitor and the PC. 3. Connect the separate power cable to the monitor and a grounded outlet.
3. Adjusting your monitor Functions of the buttons and indicator Item Function Enter Enter OSD menu, select item, enter submenu, and confirm recall. 1. Positive adjustment, change within several selections. X 2. Hot key of "Brightness". 1. Minus adjustment, change within several selections. W 2. Hot key of "Contrast". 1. Leave menu, cancel recall. (Settings will be saved automatically after adjustments are made.) Exit 2. Hot key of "Input Select".
Miscellaneous * Select "Miscellaneous" adjustment submenu Brightness * Adjust the luminance of the screen Contrast * Adjust the contrast level of the screen H. Position * Shift the screen left or right V. Position * Shift the screen up or down Pixel Clock * Adjust the monitor internal sampling clock rate Phase * Adjust the monitor internal signal phase OSD H. Position * Shift the OSD left or right OSD V.
4. Troubleshooting Symptom Remedy *Blank Screen* Power indicator is off Power indicator lights orange Power indicator lights green "No Signal Detected!" message • Make sure the power cable is connected properly (see Installation on page 4). • Make sure that the monitor was turned on using the power switch (see To connect the monitor to your PC on page 4). • Perhaps a power saving mode is active? Press any key on your keyboard or move the mouse.
5. Specifications 21.5’’ Wide-Screen LCD monitor Item Monitor Display Size Pixel Pitch Display Colors Input Signal Frequency Panel Connector Tilt Dimensions (W x H x D) Weight Power 8 Specifications T2210HD/T2210HDA 476.64 (H) x 268.11 (V) mm 0.248 (H) x 0.248 (V) mm 16.7M colors Horizontal: 30 - 83 KHz Analog Digital Tilt Angle Vertical: 56 - 76 Hz D-sub 15 pin DVI 24 pin (Not for T2210HDA) -5° - 20° Net 516.4(W) x 386.7(H) x 211.6(D) mm Net AC Consumption 4.
