User Manual
Table Of Contents
- Copyright
- Disclaimer
- BenQ ecoFACTS
- Introduction
- Installation
- Environment check
- Assembling the InstaShow Host
- Setting up the InstaShow Host
- Positioning the InstaShow Host antennas
- Connecting the HDMI cable and power
- Setting up and powering an InstaShow Button
- Pairing a InstaShow Button and InstaShow Host
- Waking up the InstaShow Host
- Storing InstaShow Buttons in the cradle
- Resetting a InstaShow Host
- Resetting a InstaShow Button
- Starting and stopping presentations
- Web management
- Troubleshooting
41 Web management
information from RX Resolution. If the source connection is made but the device is not presenting,
it shows Disconnect in RX Resolution.
You can enter messages under Screen Message. After filling in a message, press Apply to proceed.
Your message will be shown on the upper right corner of Guide/Idle Screen above SSID.
WAN
Click WAN and you will see the default WAN IP Address of the InstaShow Host. The default
connection type is DHCP. Acquire the IP Address from your DHCP server of your network. If you
want to change your WAN IP Address, choose Static IP under WAN Connection Type. You
For Screen Message, the maximum lines allowed are 3, and the maximum number of characters allowed per line
is 19.