User Manual
Table Of Contents
- Copyright
- Disclaimer
- BenQ ecoFACTS
- Introduction
- Installation
- Environment check
- Assembling the InstaShow Host
- Setting up the InstaShow Host
- Positioning the InstaShow Host antennas
- Connecting the HDMI cable and power
- Setting up and powering an InstaShow Button
- Pairing a InstaShow Button and InstaShow Host
- Waking up the InstaShow Host
- Storing InstaShow Buttons in the cradle
- Resetting a InstaShow Host
- Resetting a InstaShow Button
- Starting and stopping presentations
- Web management
- Troubleshooting
29 Starting and stopping presentations
Starting and stopping presentations
This section will guide you on how to start and stop a presentation using InstaShow™.
Getting ready
Make sure that all the connected devices have been powered on and ready for the presentation.
As your InstaShow™ could work with different projectors, IFPs, TVs, or monitors with standard
HDMI ports, the steps required to start a presentation may vary according to the actual environment
and your display specifications. Follow the procedures below and refer to the specified sections for
details.
1. To start a presentation, see Starting presentation on page 29 for details.
2. To stop a presentation, see Idle presentation on page 31 for details.
3. To learn more about InstaVideo, see Play video with InstaShow™ on page 32 for details.
Starting presentation
1. Make sure power is supplied to the InstaShow Host. See Connecting the HDMI cable and power
on page 16 for more information.
2. Choose the HDMI source corresponding to the InstaShow Host on the display. You will see the
Guide screen.
Depending on the purchased model, you may have different cable(s) on InstaShow Buttons. Connect the
InstaShow Button’s jack(s) to the corresponding input(s) of a laptop
.
Guide
Screen