User Manual
Table Of Contents
- Copyright
- Disclaimer
- BenQ ecoFACTS
- Introduction
- Installation
- Environment check
- Assembling the Host
- Setting up the Host
- Positioning the Host antennas
- Connecting the HDMI cable and power
- Setting up and powering a Button
- Using Cable USB A(F) to USB A(M)
- Pairing a Button and Host
- Storing Buttons and USB cable in the cradle
- Resetting a Host
- Resetting a Button
- Enabling network standby mode
- Starting and stopping presentations
- Web management
- Troubleshooting
60 Web management
3. Click the Firmware Upgrade button in the Firmware File field.
• Upgrading the Button’s Firmware
You can upgrade the Button’s firmware using an upgrade file located on your local computer or
directly from your Host via the connection between the Button and Host.
To upgrade the Button’s firmware using an upgrade file located on your local computer follow the
steps below:
1. Select from a local file in the Firmware File field and then click the Select File button.
2. Navigate to and select the firmware upgrade file.
When performing any type of upgrade DO NOT do any of the following:
• Power off or press the reset button on the Host or Button.
• Close the browser window of the web management interface.
Failure to follow these warnings will result in firmware upgrade failure and subsequent product failure.