User Manual
Table Of Contents
- Copyright
- Disclaimer
- BenQ ecoFACTS
- Introduction
- Installation
- Environment check
- Assembling the Host
- Setting up the Host
- Positioning the Host antennas
- Connecting the HDMI cable and power
- Setting up and powering a Button
- Using Cable USB A(F) to USB A(M)
- Pairing a Button and Host
- Storing Buttons and USB cable in the cradle
- Resetting a Host
- Resetting a Button
- Enabling network standby mode
- Starting and stopping presentations
- Web management
- Troubleshooting
49 Web management
Pairing
Click Pairing and you will see Pairing and Pairing Status.
Pairing is used when the Host is attached to the ceiling as it is not easy to press the PAIRING key
of the Host when the device is high on the ceiling. You can pair a Button and Host via the web
management interface.
1. Connect the Button’s HDMI and USB jacks to the corresponding ports of a laptop.
2. When the Button is successfully connected to the laptop, the LED indicator of the Button will
blink green.
3. Make sure the Host is properly connected to a power source.
4. Enable the 2.4G Wi-Fi channel in the Wi-Fi Radio Setup menu.
USB
3.0
HDMI
1.4