User Manual
Table Of Contents
- Copyright
- Disclaimer
- BenQ ecoFACTS
- Introduction
- Installation
- Environment check
- Assembling the Host
- Setting up the Host
- Positioning the Host antennas
- Connecting the HDMI cable and power
- Setting up and powering a Button
- Using Cable USB A(F) to USB A(M)
- Pairing a Button and Host
- Storing Buttons and USB cable in the cradle
- Resetting a Host
- Resetting a Button
- Enabling network standby mode
- Starting and stopping presentations
- Web management
- Troubleshooting
37 Web management
Logging into the web management interface via LAN
If your Host is connected to your LAN, you can enter the IP Address shown on the screen via a web
browser.
Logging into the web management interface via a wireless network
The product supports 802.11 ac/n. It is compatible with most devices with Wi-Fi capability (e.g.
laptop or mobile devices), you can locate the Host via the WDC20_xxxxxx SSID (shown in the
Guide/Idle screen) in your laptop or mobile device’s wireless network menu and connect to it. The
default password is the same as the name of the SSID (for example, if the SSID is "WDC20_c7a3ae",
the password will be "WDC20_c7a3ae"). When the device is connected to the Host, enter the IP
Address, "192.168.168.2" in a web browser, then enter the user name and password as shown in step
4 of Logging into the web management interface via direct connection on page 35.
The following is an example of how you can log into the web management interface via a mobile
device with IEEE 802.11ac.