User Manual
Table Of Contents
- Copyright
- Disclaimer
- BenQ ecoFACTS
- Introduction
- Installation
- Environment check
- Assembling the Host
- Setting up the Host
- Positioning the Host antennas
- Connecting the HDMI cable and power
- Setting up and powering a Button
- Using Cable USB A(F) to USB A(M)
- Pairing a Button and Host
- Storing Buttons and USB cable in the cradle
- Resetting a Host
- Resetting a Button
- Enabling network standby mode
- Starting and stopping presentations
- Web management
- Troubleshooting
25 Installation
3. Press the PAIRING key of the Host for five seconds, the LED indicator of the Host will blink
blue for two minutes, waiting to pair with a Button.
4. Press the split screen key on the side of the Button for five seconds. The LED indicator of the
Button will blink blue for about 10 seconds. The pairing process is ongoing. The “Pairing in
progress” message will be shown on the screen.
If the Host is attached to the ceiling so that it is not easy to press the PAIRING key, please use the pairing
process in the web management interface. Refer to Pairing on page 49 for information.
The images are for reference only. Each product has different serial number.
00:00:00
00:00:05
00:00:00
00:00:05
Pairing in progress