User Manual
Table Of Contents
- Copyright
- Disclaimer
- BenQ ecoFACTS
- Introduction
- Installation
- Environment check
- Assembling the Host
- Setting up the Host
- Positioning the Host antennas
- Connecting the HDMI cable and power
- Setting up and powering a Button
- Using Cable USB A(F) to USB A(M)
- Pairing a Button and Host
- Storing Buttons and USB cable in the cradle
- Resetting a Host
- Resetting a Button
- Enabling network standby mode
- Starting and stopping presentations
- Web management
- Troubleshooting
24 Installation
Pairing a Button and Host
A product set includes a Host and two Buttons, which are paired before shipment. In such a case, you
don’t need to pair them again. However, if you buy two or more product sets, and you want to pair a
Button with a different Host, you need to follow the instruction below. If you buy an additional
Button kit, and you want to pair the new Buttons with your Host, you need to follow the instruction
below as well.
When the Host is placed on a table
1. Make sure your Host is ready with power supply. Connect the Button’s HDMI and USB jacks to
the corresponding inputs of a laptop.
2. When the new Button is connected to the laptop, the LED indicator of the Button will flash red.
The Button is in pairing mode, waiting to pair with your Host.
If a Button nearby has been paired with a Host before, it will turn static green.
USB
3.0
HDMI
1.4