User Manual
Table Of Contents
- Copyright
- Disclaimer
- BenQ ecoFACTS
- Introduction
- Installation
- Environment check
- Assembling the Host
- Setting up the Host
- Positioning the Host antennas
- Connecting the HDMI cable and power
- Setting up and powering a Button
- Using Cable USB A(F) to USB A(M)
- Pairing a Button and Host
- Storing Buttons and USB cable in the cradle
- Resetting a Host
- Resetting a Button
- Enabling network standby mode
- Starting and stopping presentations
- Web management
- Troubleshooting
22 Installation
3. The LED indicator of the Button will flash green while the Button is starting up.
4. When the Button is ready to present, the LED indicator will turn solid green. Press the Present
key when the LED indicator turns green.
• Handle the Button cable with care. Rough handling might cause defects.
• Pull/Push the plug instead of the cable when inserting or removing Buttons.