User Manual
Table Of Contents
- Copyright
- Disclaimer
- BenQ ecoFACTS
- Introduction
- Installation
- Environment check
- Assembling the Host
- Setting up the Host
- Positioning the Host antennas
- Connecting the HDMI cable and power
- Setting up and powering a Button
- Using Cable USB A(F) to USB A(M)
- Pairing a Button and Host
- Storing Buttons and USB cable in the cradle
- Resetting a Host
- Resetting a Button
- Enabling network standby mode
- Starting and stopping presentations
- Web management
- Troubleshooting
21 Installation
2. The LED indicator of the Button will flash green while the Button is starting up.
3. When the Button is ready to present, the LED indicator will turn solid green. Press the Present
key when the LED indicator turns green.
If you purchase an additional Button (via a Button Kit), please follow the process described below:
1. Follow the pairing instructions described in Pairing a Button and Host on page 24.
2. Connect the Button’s HDMI and USB jacks to the corresponding inputs of a laptop. See the
illustration.
• If the Button encounters problems while pairing with the Host during startup the LED indicator will flash red.
Repeat the previous the process again until the LED turns solid green. See LED indicators of the Button and
the Host on page 10 for more information on LED behavior.
• Handle the Button cable with care. Rough handling might cause defects.
• Pull/Push the plug instead of the cable when inserting or removing Buttons.
USB
3.0
HDMI
1.4