User Manual
Table Of Contents
- Copyright
- Disclaimer
- BenQ ecoFACTS
- Introduction
- Installation
- Environment check
- Assembling the Host
- Setting up the Host
- Positioning the Host antennas
- Connecting the HDMI cable and power
- Setting up and powering a Button
- Using Cable USB A(F) to USB A(M)
- Pairing a Button and Host
- Storing Buttons and USB cable in the cradle
- Resetting a Host
- Resetting a Button
- Enabling network standby mode
- Starting and stopping presentations
- Web management
- Troubleshooting
19 Installation
Connecting the HDMI cable
Connect the HDMI cable to the HDMI out jack of the Host and the HDMI input jack of the
projector.
Power supply via a power adapter
(If an extender power cable is included in the package)
Connect the male connector of the extender power cable to the power jack of the Host, then
connect the supplied power adapter to the female connector of the extender power cable, and then
plug the other end of the power adapter into a wall socket. Once the connection is set up press the
power switch on the extender power cable to supply power to the Host, the LED indicator on the
standby button of the Host lights up static green when the power is supplied.
HDMI
HDMI
HDMI
POWER
HDMI
Extender Power Cable
(EU Countries Only)