User Manual
Table Of Contents
- Copyright
- Disclaimer
- BenQ ecoFACTS
- Introduction
- Installation
- Environment check
- Assembling the Host
- Setting up the Host
- Positioning the Host antennas
- Connecting the HDMI cable and power
- Setting up and powering a Button
- Using Cable USB A(F) to USB A(M)
- Pairing a Button and Host
- Storing Buttons and USB cable in the cradle
- Resetting a Host
- Resetting a Button
- Enabling network standby mode
- Starting and stopping presentations
- Web management
- Troubleshooting
17 Installation
• Avoid positioning the antennas in a horizontal manner, this may result in a weak signal reception:
• If the Host is attached to a metallic ceiling mount ensure that the antennas are at least 3 cm away
from the metal portion of the ceiling mount:
For table placement
Position the antennas so that they are both pointed upwards roughly perpendicular to the table:
Connecting the HDMI cable and power
Once the Host has been positioned properly near the display, connect the HDMI cable and power to
ensure signal transmission.
3 cm
3 cm