User Manual
Table Of Contents
- Copyright
- Disclaimer
- BenQ ecoFACTS
- Introduction
- Installation
- Environment check
- Assembling the Host
- Setting up the Host
- Positioning the Host antennas
- Connecting the HDMI cable and power
- Setting up and powering a Button
- Using Cable USB A(F) to USB A(M)
- Pairing a Button and Host
- Storing Buttons and USB cable in the cradle
- Resetting a Host
- Resetting a Button
- Enabling network standby mode
- Starting and stopping presentations
- Web management
- Troubleshooting
16 Installation
Positioning the Host antennas
Once you have properly installed the Host, follow the guidelines below to position the antennas to
maximize signal reception:
For ceiling installation
Position the antennas so that they are both pointed downwards at an angle roughly perpendicular to
the ceiling:
For ceiling mount installation
• Position the antennas so that they are both point either upwards or downwards roughly parallel to
the ceiling mount:
• If you encounter bad signal reception after initial use of the Host you can manually adjust the
antennas so that they tilt at a slight angle to maximize signal reception. When doing so, avoid tilting
the antennas toward the ceiling mount: