User Manual
Table Of Contents
- Copyright
- Disclaimer
- BenQ ecoFACTS
- Introduction
- Installation
- Environment check
- Assembling the Host
- Setting up the Host
- Positioning the Host antennas
- Connecting the HDMI cable and power
- Setting up and powering a Button
- Using Cable USB A(F) to USB A(M)
- Pairing a Button and Host
- Storing Buttons and USB cable in the cradle
- Resetting a Host
- Resetting a Button
- Enabling network standby mode
- Starting and stopping presentations
- Web management
- Troubleshooting
15 Installation
Installing the Host on the wall or trolley
If you need to install the Host near a display:
1. Stick double-sided tape to the lid of the Host.
2. Affix the Host on the wall near the display.
3. Keep the antennas away from any signal obstructions.
You can also place the Host on a mobile display trolley. See the illustration.
• Please only use double-sided sponge tape on the lid of the Host.
• Please wait 24 hours after you attach the double-sided sponge tape to the lid of the Host.