User Manual
Table Of Contents
- Copyright
- Disclaimer
- BenQ ecoFACTS
- Introduction
- Installation
- Environment check
- Assembling the Host
- Setting up the Host
- Positioning the Host antennas
- Connecting the HDMI cable and power
- Setting up and powering a Button
- Using Cable USB A(F) to USB A(M)
- Pairing a Button and Host
- Storing Buttons and USB cable in the cradle
- Resetting a Host
- Resetting a Button
- Enabling network standby mode
- Starting and stopping presentations
- Web management
- Troubleshooting
12 Installation
Assembling the Host
Assemble the Host with four antennas by turning the antennas clockwise (right) and
counterclockwise (left) to fasten them tightly.
Setting up the Host
You are provided with four different ways to position the Host. The total weight of the Host Unit is
330g.
Attaching the Host to the ceiling
1. Place the lid on the ceiling and locate the alignment hole.
2. Use the screws provided to lock the lid to the ceiling.
3. Lock the first hole (1).
4. Follow the instruction in the illustration below to lock the other holes (2-4).
5. Rotate the Host counterclockwise to affix the Host to the lid.
• Please only use the screws (M3*16 tapping screw) provided with the kit to mount the Host to the ceiling.
• Please see Positioning the Host antennas on page 16 for guidelines on positioning the antenna to maximize
signal reception.
1
2
34
Alignment hole