User Manual
Table Of Contents
- Copyright
- Disclaimer
- BenQ ecoFACTS
- Introduction
- Installation
- Environment check
- Assembling the Host
- Setting up the Host
- Positioning the Host antennas
- Connecting the HDMI cable and power
- Setting up and powering a Button
- Using Cable USB A(F) to USB A(M)
- Pairing a Button and Host
- Storing Buttons and USB cable in the cradle
- Resetting a Host
- Resetting a Button
- Enabling network standby mode
- Starting and stopping presentations
- Web management
- Troubleshooting
10 Introduction
LED indicators of the Button and the Host
Please refer to the tables below for detailed indicator and status descriptions for the Button and the
Host.
9. Lid
Refer to Attaching the Host to the ceiling on page
12 for more information.
LED indicator on the
Button
Status Description
Static blue The device is presenting.
Flashing blue The device is in the process of pairing
Flashing green
• The device is starting up and connecting to
the host.
• The device is downloading the firmware.
Static green
The device is connected and working
normally.
Flashing red The device is unable to connect to a host.
Off The device is powered off.
Quick flashing green The device is upgrading the firmware.
Static white The device is in network standby mode.
LED indicator on the
Host
Status Description
Static blue Connected device is presenting.
Flashing blue
The device is in the process of pairing.
Flashing green
• The device is starting up.
• The device is upgrading the firmware.
Static white The device is in network standby mode.
Static green The device is on and ready for connection.
Off The device is powered off.
Alignment hole
Lid of the Host
9