User Manual

22
7. Install the I/O cover.
Gently lift the display up and extend it to the maximum
extended position. Then tilt the monitor to install/remove
the I/O cover easily.
Align the I/O cover with the holes on the back of the
monitor, and press the sides and the bottom of the cover
against the holes to lock it into place. Push from the
bottom of the cover and check if it has been installed
properly.
8. Adjust the monitor height.
To adjust the monitor height, hold both the top and the
bottom of the monitor to lower the monitor or lift it up to
the desired height.
Your monitor is an edge-to-edge monitor and should be handled
with care. Avoid finger pressure on the screen surface. Excessive
force on the display is prohibited.
Avoid placing hands on the upper or lower part of the
height-adjustable stand or at the bottom of the monitor, as
ascending or descending monitor might cause personal injuries.
Never place your hand on the stand either when tilting the
monitor upward or downward. Keep children out of reach of
the monitor while performing this operation.