User Manual

87 Maintenance
8. As shown in the figure, insert the new lamp. Align the
lamp connector and 2 sharp points with the projector
and push the lamp a bit into the locked position.
9. Insert the lamp connector.
10. Tighten the screw(s) that secures the lamp.
11. Ensure the handle is fully laid flat and locked in place.
12. Replace the lamp cover on the projector.
13. Tighten the screw that secures the lamp cover.
14. .Connect the power and restart the projector.
Resetting the lamp timer
15. After the startup logo, open the On-Screen Display
(OSD) menu. Go to Advanced Menu - Settings > Lamp Settings and press OK. The Lamp
Settings page appears. Highlight Reset Lamp Timer and press OK. A warning message is
displayed asking if you want to reset the lamp timer. Highlight Reset and press OK. The lamp time
will be reset to “0”.
• Pulling it too quickly may cause the lamp to break and scatter
broken glass in the projector.
• Do not place the lamp in locations where water might splash
on it, children can reach it, or near flammable materials.
• Do not insert your hands into the projector after the lamp is
removed. The sharp edges inside the projector may cause
injuries. If you touch the optical components inside, it could
cause color unevenness and distortion of the projected
images.
• Loose screw may cause a bad connection, which could
result in malfunction.
• Do not over tighten the screw.
• Loose screw may cause a bad connection, which could
result in malfunction.
• Do not over tighten the screw.
Do not reset if the lamp is not new or replaced as this could cause damage.
8
8
9
10
11