Quick Start Guide
Table Of Contents
- Copyright
- Disclaimer
- Display installation guide
- Video wall installation guide
- Precautions
- Notes on moving the display
- Installing
- Installing edge finishing kit: PL460/PH460/PH550/PL550
- Making a daisy chain
- Different types of daisy chain
- Operating Instructions of Edge Alignment Kit/Pin: PL490/PL552/PL553/PH5501/PH5502
- Tiling: PL490/PL552/PL553/PH5501/PH5502
- Operating Instructions of Edge Alignment Kit/Pin: PL4901/PL5501/PL5502
- Tiling: PL4901/PL5501/PL5502
- Special signage installation guide
- Mounting installation
- Digital Signage Bar-Type Series
- Digital Signage Rotation/Portrait Guide
- Troubleshooting
- Preventing afterimage burn-in
- Appendix 1: Installation Checklists
- Appendix 2: Basic Troubleshooting Checklists for IFP & IL series
- Appendix 3: Basic Troubleshooting Checklists for Video Wall
- Appendix 4: Basic Troubleshooting Checklists for X-Sign
52 Mounting installation
4. Remove the flat head screws (M3xL8) (C) with a Phillips screwdriver before pulling open
the plastic cover to the left and right.
5. Remove the spring washer and nut from the expansion screw and secure the bracket (A)
to the ceiling.
Install panel display to the bracket
Secure the display frame (E) to the display with the included flat head screws (M4xL10) (D) by a
Phillips screwdriver.
Secure device box to the bracket
1. Remove flat head screws (M3xL8) (C) with a Phillips screwdriver before removing the front
cover of the device box (F).
2. Secure the display box (F) to the display with the included flat head screws (M3xL8) (C) by
a Phillips screwdriver.
Places washers in sequence as shown below when securing the bracket to ceiling: Bracket (A)=> spring washer
=> nut