Quick Start Guide
Table Of Contents
- Copyright
- Disclaimer
- Display installation guide
- Video wall installation guide
- Precautions
- Notes on moving the display
- Installing
- Installing edge finishing kit: PL460/PH460/PH550/PL550
- Making a daisy chain
- Different types of daisy chain
- Operating Instructions of Edge Alignment Kit/Pin: PL490/PL552/PL553/PH5501/PH5502
- Tiling: PL490/PL552/PL553/PH5501/PH5502
- Operating Instructions of Edge Alignment Kit/Pin: PL4901/PL5501/PL5502
- Tiling: PL4901/PL5501/PL5502
- Special signage installation guide
- Mounting installation
- Digital Signage Bar-Type Series
- Digital Signage Rotation/Portrait Guide
- Troubleshooting
- Preventing afterimage burn-in
- Appendix 1: Installation Checklists
- Appendix 2: Basic Troubleshooting Checklists for IFP & IL series
- Appendix 3: Basic Troubleshooting Checklists for Video Wall
- Appendix 4: Basic Troubleshooting Checklists for X-Sign
17 Display installation guide
4. Connect the computer to the faceplate using a suitable USB cable.
• Refer to the documentation of the active USB-CAT converter for the maximum length of the Category
5/5e/6 network cable.
• The type of USB port and plug on the active USB-CAT converter may be different from the description
above. Use a USB cable that matches the USB jack on the display and the USB port on the active USB-
CAT converter.
• Keep the Category 5/5e/6 network cable away from power lines and cables to avoid electronic
interference.
• The total length of the USB cables used to connect the display to the active USB-CAT converter,
converter to the faceplate and computer to the faceplate should not exceed 5 meters.
USB cable
USB-CAT converter
USB cable
Category 5/5e/6
network cable
Computer
USB cable
Faceplate
Display
USB port