Quick Start Guide
Table Of Contents
- Copyright
- Disclaimer
- Display installation guide
- Video wall installation guide
- Precautions
- Notes on moving the display
- Installing
- Installing edge finishing kit: PL460/PH460/PH550/PL550
- Making a daisy chain
- Different types of daisy chain
- Operating Instructions of Edge Alignment Kit/Pin: PL490/PL552/PL553/PH5501/PH5502
- Tiling: PL490/PL552/PL553/PH5501/PH5502
- Operating Instructions of Edge Alignment Kit/Pin: PL4901/PL5501/PL5502
- Tiling: PL4901/PL5501/PL5502
- Special signage installation guide
- Mounting installation
- Digital Signage Bar-Type Series
- Digital Signage Rotation/Portrait Guide
- Troubleshooting
- Preventing afterimage burn-in
- Appendix 1: Installation Checklists
- Appendix 2: Basic Troubleshooting Checklists for IFP & IL series
- Appendix 3: Basic Troubleshooting Checklists for Video Wall
- Appendix 4: Basic Troubleshooting Checklists for X-Sign
13 Display installation guide
Connecting faceplate
1. Connect the mini-B plug of the supplied USB cable to the USB Mini-B port on the display,
and the type-A plug of the cable to the USB port on the faceplate.
2. Connect the computer to the faceplate using a suitable USB cable.
• Refer to the User Manual of your display for the location of USB port.
• Any cable used in prior installations for other displays and projectors in the same location should not be
used for a new installation of the display.
• Use only a high-quality faceplate.
• The total cable length between the display, computer and faceplate should not exceed 5 meters. If you
need to extend the length of USB connection, refer to "Extending USB connection" on page 14.
Faceplate
USB cable
Computer
USB cable
Display
USB port