Quick Start Guide
Table Of Contents
- Copyright
- Disclaimer
- Display installation guide
- Video wall installation guide
- Precautions
- Notes on moving the display
- Installing
- Installing edge finishing kit: PL460/PH460/PH550/PL550
- Making a daisy chain
- Different types of daisy chain
- Operating Instructions of Edge Alignment Kit/Pin: PL490/PL552/PL553/PH5501/PH5502
- Tiling: PL490/PL552/PL553/PH5501/PH5502
- Operating Instructions of Edge Alignment Kit/Pin: PL4901/PL5501/PL5502
- Tiling: PL4901/PL5501/PL5502
- Special signage installation guide
- Mounting installation
- Digital Signage Bar-Type Series
- Digital Signage Rotation/Portrait Guide
- Troubleshooting
- Preventing afterimage burn-in
- Appendix 1: Installation Checklists
- Appendix 2: Basic Troubleshooting Checklists for IFP & IL series
- Appendix 3: Basic Troubleshooting Checklists for Video Wall
- Appendix 4: Basic Troubleshooting Checklists for X-Sign
12 Display installation guide
Extending the HDMI connection using an HDMI amplifier/repeater
Although there is not an official limit on HDMI cable length (as it mainly depends on the quality
of the HDMI cable), in order to prevent potential display quality problems like interference and
ghosting, if you need to connect the display to a computer or an A/V device (such as a DVD or
Blu-ray player) over 5 meters, deployment of an HDMI signal amplifier is highly recommended.
1. Connect the HDMI input jack on the display to the HDMI output jack on the HDMI signal
amplifier/repeater.
2. Connect the HDMI input jack on the HDMI signal amplifier/repeater to the HDMI output
jack on the HDMI source device using an HDMI cable.
• Refer to the User Manual of your display for the location of HDMI input jacks.
• The HDMI cables and HDMI signal amplifier/repeater are not supplied and should be purchased
separately.
HDMI cable
HDMI cable
DVD/Blu-ray player or
computer
HDMI signal
amplifier/repeater
HDMI input jack
Display