User Manual

14
6.11.01 S46 US DRAFT A31008-H5450-A5-*
Getting Started
Charge battery
The battery is not fully charged
when delivered. You should there-
fore:
• Plug in charger cable at the bot-
tom of the phone and plug in the
power supply unit to the power
supply (only use the charger sup-
plied; charge for at least two
hours).
• Push the sides of the charger ca-
ble plug together and pull to re-
move it.
Charging
The following is shown at the top of the dis-
play:
Q
When charging is in progress.
P
End of charging.
An empty battery is fully charged after
about 2 hours. Charging is only possible in
an ambient temperature of 5°C to 40°C
(the charge icon flashes as a warning when
the temperature is 5°C above/below). The
voltage specified on the power supply unit
must not be exceeded.
Standby time
A fully charged battery provides 60 to 300
hours of standby time or 100 to 360 minutes
of talk time. The standby times/talk times
are average values and depend on the op-
erating conditions (see table below).
Charge level display (fully charged to emp-
ty):
R S T U V
A beep sounds when the battery is nearly
empty.
Battery totally discharged
If your mobile phone will not switch on and
no charge icon is displayed when you plug
in the charger, it may be that the battery is
totally discharged and has to be reactivat-
ed.
If this is the case, leave the charger cable
plugged in. The charge icon will appear af-
ter a maximum of 2 hours. The battery is
then automatically recharged.
Decrease of standby time
Operation car-
ried out
Time
(min)
Decrease of
tstandby time
Callingl 1 30 to 60 minutes
Display back
light *
1 30 minutes
Network search 1 5 to 10 minutes
* key input, games, organizer etc.