Instructions

1.1 General notes
Introduction
5178 / 03/2021 enBENNING EV 3-26
1 Introduction
The BENNINGEV3-2 measuring adapter described here (in the following only referred to as
“device”) is an optional accessory for the BENNINGIT130 and IT200 installation testers. The
BENNINGEV3-2 measuring adapter enables you to perform safety and functional tests on
certain charging stations for electric vehicles (EVSE, electric vehicle supply equipment) in
compliance with DINVDE0100-600 (IEC60364-6) and DINVDE0105-100 (EN50110) using
the corresponding installation tester.
The device is intended for testing charging stations according to DINEN/ IEC61851-1
(VDE0122-1) of charging mode “Mode3” and is provided with a Type2 connector according to
IEC/ EN62196. The “Mode3” charging mode is used for 1-phase and 3-phase charging with
alternating current (AC) at permanently installed charging stations (so called “wall boxes”).
The device establishes safe contact with the BENNING installation tester and triggers the
charging process of the charging station by simulating an electric vehicle (EV).
Further information
http://tms.benning.de/ev3-2
On the Internet, you will find the following additional information directly at the specified link or
at www.benning.de (product search):
• Operating manual of the device in several languages
• Further information depending on the device (e.g. brochures, technical reports, FAQs)
1.1 General notes
Target group
This operating manual is intended for the following groups of people:
• Qualified electricians and qualified technical personnel
Required basic knowledge
To understand these operating manual, you will need general knowledge of testing and
measuring equipment. Moreover, you will need basic knowledge of the following issues:
• General electrical engineering
Purpose of the operating manual
This operating manual describes the device and provide you information about how to handle it.
Keep this operating manual in a safe place for later use. Read this operating manual before
handling the device and follow the instructions.