Instructions

4.1 Device structure
Device description
5178 / 03/2021 enBENNING EV 3-214
4 Device description
4.1
Device structure
1
2
3
4
5
6
7
8
Figure1: BENNINGEV3-2 device structure
1 4mm test sockets (N, PE, L1, L2, L3)
for connection to the installation tester
2 BNC socket (output) for testing the CP
signal
3 Test cable 4 Type2 connector (male) for connection
to the charging station (EVSE)
5 Rotary switch “CP-Status/
State” (control pilot)
6 Test socket for connection to the
installation tester
7 Rotary switch “PP-Status/
State” (proximity pilot or plug present)
8 LEDs for phase indication L1, L2 and
L3 (output voltage of the charging
station/ EVSE)
WARNING
Improper use
Danger to life or serious injury is possible due to contact with high electric voltage in case of
incorrect use of the test socket or 4mm test sockets. The device might get damaged. The test
socket and the 4mm test sockets carry mains voltage as soon as one or more LEDs for phase
indication light up.
• Use the test socket, 4mm test sockets and BNCsocket only for the testing purposes
described.
• Do not connect any other load to the test socket.
• The BNCsocket is intended for connection to an oscilloscope.