Instructions

28

12/ 2019 BENNING MM 10 –PV/ MM 10 –1
Operating Manual
BENNING MM 10-PV/ MM 10-1
TRUE RMS digital multimeter for
- DC/ AC voltage measurements
- DC/ AC current measurements
- resistance measurements
- continuity and diode tests
- capacity measurement
- frequency measurement
- temperature measurement
Table of contents
1. User instructions
2. Safety instructions
3. Scope of delivery
4. Device description
5. Functions of the digital multimeter
5.1 General information
5.2 Data logger functions
5.2.1 Setting the data logger
5.2.2 Automatic storage (LOG)
5.2.3 Manual storage (SAVE)
5.3 Data transmission to the smartphone/ tablet
6. Ambient conditions
7. Electrical specifications
8. Measuring with the BENNING MM 10-PV/ MM 10-1
9. Maintenance
10. Technical data of measuring accessories
11. Environmental note
1. User instructions
This operating manual is intended for
- skilled electricians and
- electrotechnically trained personnel.
The BENNING MM 10-PV/ MM 10-1 is intended for measurements under dry am-
bient conditions. It must not be used in electrical circuits with a nominal voltage
higher than 1000 V AC/ DC (see section 6 „Ambient conditions“).
The following symbols are used in this operating manual and on the BENNING
MM 10-PV/ MM 10-1:
Attention! Magnets might a󰀨ect the correct functioning of cardiac pace-
makers and implanted debrillators. As a user of such medical devices,
keep a su󰀩cient distance to the magnet.

Warning of electrical danger!
Indicates instructions which must be followed to avoid danger to per-
sons.

Attention! Must comply with documentation!
This symbol indicates that the information provided in the operating
manual must be complied with in order to avoid risks.
CAT II
Measuring category II is applicable to testing and measuring circuits
which are directly connected to user connections (sockets and similar
connections) of the low-voltage mains installation.
CAT III
Measuring category III is applicable to testing and measuring circuits
connected to the distribution circuit of the low-voltage mains installa-
tion of a building.
CAT IV
Measuring category IV is applicable to testing and measuring circuits
connected to the feed-in point of the low-voltage mains installation of
a building.

This symbol on the BENNING MM 10-PV/ MM 10-1 indicates that the
BENNING MM 10-PV/ MM 10-1 is equipped with protective insulation
(protection class II).
Please observe the operating manual!