Specifications

Operation Manual
EL640.400-C2, -C3 and -
CD3 Display
Beneq Products Oy
Olarinluoma 9
Tel. [phone]
VAT ID FI25115461
FI-02200 Espoo
Fax [phone]
www.beneq.com
Finland
[e-mail]
www.lumineq.com
Date: September 23, 2014
Document number: ED000821B
Page | 12
5 Installation and handling
The product should be mounted using the M3 insert nuts on the ECA. Beside the four corner
nuts, it is recommended to use also the two center nuts in the mounting if the vibration or
shock stress is severe.
Before touching the display, necessary precaution must be taken to prevent application of
static charges on the display from the operator or tools.
The display is made of glass material and should be handled with proper care. Do not drop
the display or allow hard objects to strike its surface.
NOTE: For trouble-free data transfer, a maximum cable length of 300 mm (12 in.) from data
transmitter to display input connector is recommended. If longer cables up to 2m (80 in.)
length are needed, a serial resistor of approximately 47  could be placed at each of the four
signal line outputs of the transmitter in order to lower signal reflections.
ELECTROSTATIC CAUTION: Beneq display use CMOS and power MOS-FET devices. These
components are electrostatic-sensitive. Unpack, assemble and examine this assembly in a
static-controlled area only. When shipping, use packing materials designed for protection of
electrostatic-sensitive components.
WARNING: The product generates potentially dangerous voltages capable of causing
personal injury (high voltage pulses up to 195 V
ac
). Do not touch the display electronics
during operation!
5.1 Video input timing
Figure 3. Video input timing, 350 row VGA modes