Instruction Manual

Short tube limiter
Before starting any operation on your shotgun,
make sure that the chamber and the magazine
are unloaded!
(Carefully read the instructions on gun loading
and unloading).
WARNING
The following operations must be carried out
carefully in order to prevent the magazine
spring from escaping at high speed.
When carrying these operations out, always
wear eye protection.
If the magazine spring escapes at high velocity
severe eye injury or other injuries with serious
consequences can occur.
The same care must be taken during assembly.
To remove the limiter, proceed as follows (figs.
58-59).
1) With the gun unloaded, point the barrel
upwards and unscrew magazine cap from the
front of the weapon.
2) With appropriate pliers, remove the limiter
retainer.
3) Carefully slip the limiter and spring out.
To install the limiter, proceed as follows:
1) Insert the limiter in the spring.
2) Insert limiter and spring into the magazine
tube.
3) Fit the spring seal ring on so that there are no
protrusions from the tube.
4) Screw the fore end cap onto the end of the
magazine tube and fasten the whole barrel-
breech-fore-end unit tightly.
For models equipped with short tube magazine
plus magazine tube extension (magazine tube in
two pieces), the extension magazine tube is put
on off together when screwing the fore-end cap.
Internal choke
Before starting any operation on your shotgun,
make sure that the chamber and the magazine
are unloaded!
(Carefully read the instructions on gun loading
and unloading).
The barrels with internal chokes are equipped
with various types of chokes.
WARNING: before using the shotgun, make
sure that the barrel has a choke correctly
installed.
WARNING: the internal choke correctly mount-
ed must not stick out of the barrel’s muzzle. Use
only the Benelli internal chokes with a length
which correctly fits the barrel.
67
58
59