Instruction Manual

The shotgun is supplied with a “drop change

kit” (fig. 52) which enables you to adjust the ori-

ginal drop the shotgun is supplied with. The kit

consists of one stock locking plate (in steel), plus

drop change shims three (in plastic).

The kit enables you to obtain four different drop

patterns (as specified in the following table) and

two different deflections (right hand or left hand).

Each unit is marked with the corresponding

drop and cast letter.

Determine if your stock drop fits you perfectly, or

whether it is either too high or too low for you.

If it is too low, you need to select the previous

adjustment set in alphabetical order (e.g. if the

shim supplied on the shotgun is marked with a

“C”, you must select the “B”, together with the

corresponding stock locking plate).

Replacement procedure is very simple (figs. 53-

54):

1) Grasp the bottom of the buttpad “1” and pull

upwards (figs. 55-56).

2) Unscrew the stock retaining nut “2” (using

a 13 mm hexagon wrench).

3) Take the nut “2”, the lock washer “3”, the

stock locking plate “4”, the stock “5”, the

cast shim “6” and the drop shim “7” out of

the recoil spring tube.

1234 8 5