Instruction Manual

64
8) Hold the stock receiver assembly almost ver-
tically and insert the bolt assembly in its
guide on the receiver (fig. 50).
WARNING: make sure that the bolt link slides
over the trigger guard assembly, positioning on
the recoil spring guide pin inside the receiver,
once the mounting has been completed (fig. 51).
9) Finish assembling the shotgun by following
all the steps (except the first three) outlined
under the section on page 54.
ACCESSORIES AND ADJUSTMENTS
Drop and cast adjustment
Before beginning any operation on your shot-
gun, always make sure that chamber and
magazine have been completely emptied!
(Carefully read loading and unloading instruc-
tions).
51
50
52
Matching instructions: the drop change shims and
stock locking plates in the kit are identified by letters.
To ensure a correct drop, always use plates and shims
with the same letter, e.g.: C - CDX – for a 65-RH drop
or C - CSX – for a 65-LH drop.
DX = Right hand
SX = Left hand
DROP CHANGE SCHEDULE
Cast Stock Drop
shim locking plate shim
(plastic) (steel) (plastic)
Reference Reference Reference
letter letter letter
DX Z DX
Z
50 ± 1 DX
SX Z SX 50 ± 1 SX
DX A DX
A
55 ± 1 DX
SX A SX 55 ± 1 SX
DX B DX
B
60 ± 1 DX
SX B SX 60 ± 1 SX
DX C DX
C
65 ± 1 DX
SX C SX 65 ± 1 SX
Drop value
at heel (mm)