Instruction Manual

3) Place the bolt recoil spring in its seat on the

bolt (fig. 45).

NOTE: always make sure that the bolt recoil

spring is positioned between the locking head

and the bolt itself, in order to avoid a shot being

fired during the closing phase.

4) Slide the locking head into the bolt, making

sure that the hole on its stem coincides with

the slot on the bolt (fig. 46).

WARNING: the slanted surfaces on the locking

head’s stem should not be visible once the bolt

locking head is mounted.

5) Insert the locking head pin in its hole on the

locking head’s stem, through the slot on the

bolt (fig. 47).

NOTE: the reference line on top of the pin must

be visible and aligned with the bolt assembly

longitudinal axis (fig. 47).

6) Insert the firing pin and the firing pin spring

inside the bolt hole (fig. 48).

NOTE: always make sure that the firing pin

spring has been mounted.

7) Insert the firing pin retaining pin in its seat, so

as to block the firing pin (fig. 49).